1/21/2024 0 Comments Klv apple xsan![]() ![]() If multiple RFCs define a protocol, there may only be one listed here. RFC documents are maintained by RFC Editor. The RFC column lists the number of the Request For Comment document that defines the particular service or protocol, which may be used for reference. The names of Apple products that use these services or protocols appear in the Used By / Additional Information column. The Service or Protocol Name column lists services registered with the Internet Assigned Numbers Authority except where noted as "unregistered use". Apple products listed in the table are the most commonly used examples, not a comprehensive list. ![]() This document is intended as a quick reference and should not be regarded as comprehensive. This article is updated periodically and contains information that is available at time of publication. Note that Mac OS X v10.5 and later include an Application Firewall, which is different than a port-based firewall. ![]() Some applications require more than one port and are listed accordingly. Network administrators may also wish to use port-watching software in addition to the information in this article when making decisions about how to set up firewalls or similar access control schemes. Not all ports and services listed are used by all software products. Your network administrator may need this information to make sure your computer or device can connect to services such as automatic software updates, or the App Store. For an explanation of what a TCP or UDP port is, see the "IP Ports" section of " OS X: What Is a Port?" If you can get the Save button in the Settings screen for the SAN per Apple’s instructions then that’s preferred as it’s less work however, I have only seen that Save button selectable in Xsan 2 and below.The table below outlines TCP and UDP ports used by Apple products. The clients should be the easy part of this whole process. Provided everything removes properly restart (or launchctl unload and launchctl start ) and then readd the client from Xsan Admin. If this is the case, then force remove them from Xsan Admin (unless of course, it allows you to do so gracefully), Disable Xsan from the Xsan System Preference pane and then rm the contents of /Library/Preferences/Xsan. If they are, then you’re good on the controllers (unless you have a third controller and need to do this process on it as well).Ĭlients sometimes need to get removed from the SAN and readded. Once rebooted, check cvadmin and verify that all volumes are activated on both hosts. Don’t worry about that, just make the changes and reboot the backup. The metadata controller will initially indicate that it cannot stat the volume settings on the backup when the backup is restarted. If the volume starts and you can mount it then repeat the same process on the backup. Provided that everything works on both network interfaces, the volume should automatically start upon reboot. The file will initially have data that looks like the following (provided our Metadata Controllers are 10.0.0.1 and 10.0.0.2):Īssuming the systems have the same final octet the resulting changes would be as follows (note that these have no XML structure and are just a list of numbers separated by carriage returns): Once you’ve made your change, edit fsnameservers. 0 with a CIDR and not the actual IP address): In this case we’re going to switch from our 10.0.0.0 network to our 192.168.0.0 network (note that this is a. Then open ist from /Library/Preferences/Xsan in your favorite text editor and locate the metadataNetwork key as follows: To get started, first shut down your backup metadata controller, so in case everything goes haywire you have a back out plan. Therefore, while I hate changing network interfaces in Xsan I do find that in 10.8 and higher, I end up needing to do so by editing the config files. This typically works great except the fact that the article has been retired and in Xsan 3 the Save button never actually gets undimmed. Adjust the clients and controllers so they are on the same subnets. Note: If all controllers and clients are not on the same subnet on each network, the Save button will be dimmed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |